Honor 50 Pro RNA-TN00 Stock ROM Firmware EDL QFIL (Flash File)

August 12, 2023

Honor 50 Pro RNA-TN00 Stock ROM Firmware is now available for download and You can download it below. by using this firmware you can solve all software Issues within your Honor 50 Pro RNA-TN00 such as hang-on Logo, FRP lock, fast boot Mode, display blank or white after flash, dead recovery, dead after flash, etc.

On this page, you will find the direct link to get the official Honor 50 Pro RNA-TN00 Stock ROM Firmware (flash file) on your computer. The Firmware comes as a zip package and contains the original Firmware, Flash Tool, Driver, and How-to Flash Manual.

Note:

make a backup before the Process
it will erase all your data Including Internal Storage

Post Contents

Firmware Information:

Device Name – Honor 50 Pro RNA-TN00
ROM Type – Full ROM+ OTA’s
SoC –
OS – Android
Password –
Root Access – No
Size – GB
Region –
Firmware Version –

Downloads Links:

EDL Firmware:

Honor 50 Pro RNA-TN00 4.2.0.158

How to Flash Honor 50 Pro RNA-TN00 Stock ROM Firmware

How to use Realme Flash Tool

How to Install Stock Firmware on Honor 50 Pro RNA-TN00:

Install QFIL: Download and install the latest version of QFIL on your computer.
Download the firmware: Download the firmware file for your from above download section.
Extract Firmware File: once firmware file is downloaded extract the zip file using the 7z or winrar.’
Install Qualcomm driver: download & Install latest qualcomm 9008 usb driver on your computer
Boot your device into EDL mode: To put your device into EDL (Emergency Download) mode, follow these steps:

Turn off your device.
Hold down the volume up and volume down buttons simultaneously.
While holding the volume buttons, connect your device to your computer via USB cable.
Your device should now be in EDL mode.
Note: if still not in EDL Mod then you have to short test point

Launch QFIL: Launch QFIL on your computer.
Load the firmware: In QFIL, click on the “Flat Build” button and select the firmware file that you downloaded in step

in the Programmer option click browse and locate Prog-firehose-ddr.elf file from firmware folder
click load xml option and select rawprogram and Patch xmls

Start the flashing process: Click on the “Download” button in QFIL to start the flashing process.
Wait for the flashing process to complete: The flashing process can take several minutes to complete, depending on the size of the firmware file and the speed of your computer. do not disconnect your device from the computer during this time.
Reboot your device: Once the flashing process is complete, disconnect your device from the computer and reboot it.

Related